To be in line with other interfaces, when deleting the driver and it's glue layer to esp-netif, we DO NOT delete the related esp-netif (since is was allocated and created outside of the glue code and it works the same way in esp-eth and esp-wifi driver/glue layers).
Closes https://github.com/espressif/esp-idf/issues/5486
esp_modem_stop_ppp() stops both ppp netif and switches the modem back to
command mode. IF these two actions are not synchronised, we might
experience issues of
* active PPP session trying to send/receive uart-data
* command mode already active before modem switched to it
both resulting in crashes.
Fixed by introducing the transition mode and running these actions in sequence
* set esp-modem to transition mode
* enter command mode, wait for the reply or re-sync
* close the PPP netif
* wait until the netif closes
Other fixes include ignoring certain events if modem component not ready
or not in appropriate mode:
* ignoring all UART events comming from DTE with no DCE attached
* ignore pattern detection in PPP mode
Fixes Guru Meditation Error: Core 0 panic'ed (LoadProhibited) when config with
CONFIG_PM_ENABLE=y && CONFIG_PM_DFS_INIT_AUTO=y.
Signed-off-by: Axel Lin <axel.lin@gmail.com>
Merges https://github.com/espressif/esp-idf/pull/4904
pppos_client example used the UART default clock configuration which might
cause issues if power management enabled. Settings updated to UART_SCLK_REF_TICK
Also need to explicitly disable RX interrupts in UART pattern detection
mode.
Closes https://github.com/espressif/esp-idf/issues/4801
esp-modem netif glue layer implements esp-netif attach callback to setup corresponding driver functions and start the modem. The error code of esp_modem_start_ppp() was ignored and ESP_OK returned in all cases. Fixed by passing esp_modem_start_ppp()'s error code to post_attach callback.
Closes https://github.com/espressif/esp-idf/issues/5430
calling esp_netif_up() and esp_netif_down() was not supported if the
underlying netif wos of ppp type. Updated the code to enable setting
these interfaces up/down and registered actions in moden_netif glue for
connection/disconnection events to set the netif up/down.
When library users call esp_stop_ppp(), it is expected that the PPP link
is closed and the DCE is moved into command mode.
If the STOP event is not posted into the event loop, then the PPP stack
would not be turned off, resulting in the impossibility to switch into
command mode, as the modem is still sending PPP binary data.
Signed-off-by: Francesco Giancane <francesco.giancane@accenture.com>
Merges https://github.com/espressif/esp-idf/pull/4642
1. add support for ESP32 DTE
2. add support for SIM800/BG96 DCE
3. add PPPoS setup procedure
4. add support for SMS
5. add mqtt example after PPP connection established
