According to the application note in SD Card Physical Specification:
> The host shall set ACMD41 timeout more than 1 second to abort repeat
of issuing ACMD41 when the card does not indicate ready. The timeout
count starts from the first ACMD41 which is set voltage window
in the argument.
Previously, the timeout was exactly one second, and this caused
certain larger-capacity cards to "time out", because they couldn't
finish initialization process in time.
ACMD41 argument is different between SD mode and SPI mode.
In SPI mode, the only non-zero bit may be the HCS bit. Unlike the SD
mode, the bits reflecting the host's OCR should be zero.
Previously, we used to set these bits the same way as for the SD mode.
This has caused certain cards to fail initializing, apparently their
controllers have checked the ACMD41 argument more strictly and refused
to finish initialization, resulting in an error such as
sdmmc_common: sdmmc_init_ocr: send_op_cond (1) returned 0x107
(Note that this error may have other causes than the one fixed in
this commit. For example, if the card doesn't have a sufficient and
stable power supply, it may also fail to complete the internal
initialization process, and will never clear the busy flag in R1
response.)
Closes https://github.com/espressif/esp-idf/issues/6686
Closes https://github.com/espressif/esp-idf/issues/10542
* All components which won't build (yet) on Linux are excluded.
This enables switching to Linux in an application without
explicitly setting COMPONENTS to main in the main
CMakeLists.txt.
* ESP Timer provides headers for Linux now
* automatically disabling LWIP in Kconfig if it is not available
doc(linux): brought section
"Component Linux/Mock Support Overview" up to date
- split test cases into separate files
- added a component with information about dev. boards
- added a console application to run the tests
- added commands for lower level hacking/experimentation
sdmmc, sdspi: fixes related to status checks, R1b response support, erase fix for SPI mode, fix for erase timeout calculation
Closes IDF-4728
See merge request espressif/esp-idf!17727
Previous version of the code used a fixed constant (500 ms) for the
erase timeout and added 1 ms for each sector erased.
This commit improves timeouts calculation:
- For SD cards, check if erase timeout information is present in the
SSR register. If yes, use it for erase timeout calculation.
Otherwise assume 250ms per erase block, same as Linux does.
- For eMMC assume 250ms per erase block (but no less than 1 second).
This has to be improved later to use the erase timeout info in the
extended CSD register.
Same as for write operation, some errors are reported only via CMD13.
Without the R1b response support in sdspi driver, this check would
fail. Now that R1b support is implemented, erase command response is
zero (success) on all cards under test.
Also remove the now-unnecessary card reset after erase in the test
case.
During write operation (CMD24 or CMD25), the card can report some of
the errors in the 1-byte response tokens. Other types of errors are
not reported, the host has to get them by issuing CMD13.
This commit adds CMD13 request at the end of write operations and
reports error to the user if the card status isn't zero.
