fix(panic): fixed cache error being reported as illegal instruction
Closes IDF-6398, IDF-5657, IDF-7015, and IDF-6733
See merge request espressif/esp-idf!27430
For Linux builds if the embedded data length exceeded 16-bit value then
the build used to fail with following error:
build/x509_crt_bundle.S: Assembler messages:
build/x509_crt_bundle.S:4201: Warning: value 0x1056e truncated to 0x56e
GNU ASM for X86 systems treats .word attribute as of size 2 bytes, this commit
uses .long attribute to take the size to 4 bytes.
1. Rename ESP_SLEEP_DEEP_SLEEP_WAKEUP_DELAY to ESP_SLEEP_WAIT_FLASH_READY_EXTRA_DELAY
2. Set ESP_SLEEP_WAIT_FLASH_READY_EXTRA_DELAY visible for all targets
fix(tools): replace nvs_partition_gen.py with new esp-idf-nvs-partition-gen package
Closes IDF-8147 and IDF-1958
See merge request espressif/esp-idf!26758
feat(bootloader_support): Make `esp_secure_boot_verify_sbv2_signature_block()` function public
Closes IDFGH-11599
See merge request espressif/esp-idf!27742
The size of partition of type APP should be multiple of 4 KB. Partition
generation tool now make this as a mandatory requirement. This is
minimum flash erase size. If the size of the APP type partition is not
aligned to 4 KB then the last erase operation could go beyond the allocated
partition and hence may fail. This issue would only be observed when the
firmware size grows very close to the allocated partition size, and hence
causing the OTA update to fail.
For already deployed devices on-field with the size of APP partition not
aligned to flash sector boundary, it is best to ensure that firmware
size always remains within the lower 4 KB boundary of the total
allocated space. While migrating to ESP-IDF 5.3 release, partition table
for an existing project can be adjusted accordingly for the build to
succeed.
Found during discussion in https://github.com/espressif/esp-idf/pull/12460
When idf.py coredump-debug is launched with '--core' argument, it
tries to determine the file format (raw, elf, b64). To detect the
'raw' core dump the code checked if the version word matched one of
the known values.
However, the version word also contains the chip ID in the high
half-word, so the check failed for anything other than the ESP32.
The detection of core file format has been moved to esp-coredump
package in version 1.9.0, including the fix for chip ID.
Reported in https://github.com/espressif/esp-idf/issues/10852
Currently sbom manifest is checked only in .gitmodules and
this check is done in pre-commit and also in CI. Meaning it's running
three times(pre-commit before push if user has it enabled, in CI
as there is the pre-commit run again and again with test in CI). Since
esp-idf-sbom contains a full manifest validation support and pre-commit
plugin for it, let's use it. This removes all the current sbom testing
and replaces it with a signle pre-commit plugin which validates all
manifests files(sbom.yml, idf_component.yml, .gitmodules and also
referenced manifests) in repository. Note that this checks all
manifests, not only ones which were modified. The check is reasonably
fast though, so it should not cause any problem. The reason for
validating all manifest files is that we want to make sure that the sbom
information in .gitmodules is updated too and that the hash
recorded in .gitmodules is up-to-date. Meaning submodule update
would not trigger this plugin, because no manifest was changed.
Signed-off-by: Frantisek Hrbata <frantisek.hrbata@espressif.com>
