support line mode 1-2-4-8 depend on targets.
fix sct mode dma descriptor counter compute issue.
add conf_bits_len setting API to control interval time.
- modify console example to use the new SOC_LIGHT_SLEEP_SUPPORTED
and SOC_DEEP_SLEEP_SUPPORTED macros when registering sleep commands
- remove exclusion of esp32p4 in basic and advanced example in
.build-test-rules.yml
- replace exclusion of esp32p4 for deep and light sleep tests with newly introduced macro
- remove the temporary disable check for esp32p4 and uses the
SOC_LIGHT_SLEEP_SUPPORTED maccro instead.
Increase LP_UART_EMPTY_THRESH_DEFAULT value to 4. The original value
could cause the FIFO become empty before filling next data into the FIFO
when the buadrate is high. TX_DONE interrupt would raise before actual
transmission complete in such case.
This header has been removed for the following reasons:
- Header is misplaced. 'xxx_types.h' headers should be placed in the 'hal'
component.
- The 'usb_xxx_endpoint_t' should be placed in the 'xxx_struct.h' header.
- Renamed usb_otg_periph.h/c to usb_dwc_periph.h/c to match naming convention
of other DWC OTG related files
- Added compatibility header for usb_otg_periph.h
usb_pins.h and usb_periph.h/c lists mappings of USB DWC signals to GPIOs used
to connect to external FSLS PHYs. However, those signals can be routed to any
GPIOs via the GPIO matrix. Thus, these mapping are meaningless and have been
deprecated.
This commit updates the "*_struct.h" files for the USB OTG peripheral:
- Added/removed some missing/non-existing register fields
- Added "reserved" place holders for registers that are missing due to IP
configuration.
- Added "usb_dwc_cfg.h" listing the USB OTG IP configuration for each target.
- Updated LL/HAL according to register field updates. Also tidied up the include
directives in those headers.
This commit refactors SOC_USB_PERIPH_NUM as follows:
- Renamed to SOC_USB_OTG_PERIPH_NUM to avoid confusion with USB Serial JTAG
- Updated to unsigned integer "1U"
- Updated some build rules to depend on SOC_USB_OTG_SUPPORTED instead
Now the soc interrupts definitions are scattered around in the esp-idf
which are out of sync. Put interrupts definitions in soc/periph_defs.h
(!ESP32) or soc/soc.h(ESP32) together in soc/interrupts.h.
There are some register description errors in parts of rom/gpio.h
This commit update the incorrect comments in rom/gpio.h And now
esp_rom_gpio.h is recommend instead of rom/gpio.h. So this commit adds
macro SIG_GPIO_OUT_IDX in esp_rom_gpio_connect_out_signal
function and removes the reference to gpio.h in some source files.
Closes https://github.com/espressif/esp-idf/issues/11737
