1. Fix bug of uart frame error and parity error interrupt mismatch in driver code, which will cause the corresponding interrupt can not be cleared correctly, and will finally cause a interrupt watch dog.
2. Add gpio pull-up for rx pin and cts pin.
Minor fixes from various sources
- Fix memory debugging code. Noticed by Tuan.
- intr_enable/disable should be in IRAM. Noticed by rojer
- Still old timer code in examples in doxygen comments. Noticed on the forum by jumjum123
- Timer example was broken. Noticed on the forum by jumjum123
See merge request !325
ULP: add new instructions, fix bugs, add tests
This adds peripheral register read and write instructions, an instruction to wake the SoC from deep sleep, and some tests.
Also fixes two bugs: ANDI instruction definition, and running the ULP when in deep sleep mode.
See merge request !317
Fix exception handler to jump to correct vector instead of crashing to the double exception vector.
One-character fix... basically, this caused the exception handler to crash into the double-exception handler instead of nicy panic'ing.
See merge request !323
Secure boot: Option for app & partition table signing to happen outside build system
Allows for a remote signing server, private signing key does not need to be on the build system.
See merge request !320
Allow gw to be null
Github Pull Request 163: https://github.com/espressif/esp-idf/pull/163
Allow interfaces to be configured without a default gateway, for
local-only communication.
In case of the AP interface, if gw is not set, do not offer it.
See merge request !312
1. add sigma-delta code and example.
2. add gpio output signal in io matrix.
Squashed commits:
[a25e7d4] minor changes for doc
[6a03a1e] minor changes on comments and doc.
[97dd9e4] Add doc.
update index.rst
change example index
Starting the ULP using SENS_SAR_START_FORCE_REG doesn’t disable clock gating of RTC fast clock.
When SoC goes into deep sleep mode, RTC fast clock gets gated, so ULP can no longer run.
Instead, it has to be started using the timer (RTC_CNTL_ULP_CP_SLP_TIMER_EN bit).
When ULP is enabled by the timer, clock also gets enabled.
This change allows setting pin configuration for EXT1 wakeup depending on the state of RTC_PERIPH power domain:
- if peripherals are enabled (due to another wakeup mode, or due to esp_deep_sleep_pd_config call), we can keep internal pullups/pulldowns enabled
- if peripherals are disabled, pullups and pulldowns need to be disabled as well
Also add comments about the purpose of registers being configured.
This adds a workaround for a bug that following deep sleep wakeup, ISO (bus isolation) signal may be set for RTC fast memory.
We set FORCE_NOISO bit in RTC_CNTL_PWC_REG until we find out what is causing ISO signal to be set.
When ESP32 wakes up from deep sleep, flash is accessed an approximately 900us after power on.
Some flash chips need more time to become ready. This change adds a menuconfig option to add
some delay to the default deep sleep wake stub.
Fixes https://github.com/espressif/esp-idf/issues/117
This adds the following APIs to enable various wakeup sources:
- esp_deep_sleep_enable_timer_wakeup
- esp_deep_sleep_enable_ulp_wakeup
- esp_deep_sleep_enable_ext0_wakeup
- esp_deep_sleep_enable_ext1_wakeup
And an API to start deep sleep:
- esp_deep_sleep_start
1. TW8657, WIFI send the whole packet to smartconfig;
2. modify API annotation of smartconfig and sniffer;
3. export smartconfig APIs to programming guide;
lwip: fix lwip dual core issue
Call xSemaphoreGiveFromISR instead xSemaphoreGive when the calling context is in critical section.
See merge request !314
Restore ability to alloc IRAM, and more.
- Fix mem regions so allocating IRAM works again
- Optimize allocator slightly, uses 4 less bytes per malloc now
- Allow querying free heap memory space per memory type
See merge request !301
Bugfix/btdm bluedroid
Cleanup all the warnings。
Fix GATT CLIENT cannot receive notfiy/indicate from GATT SERVER bug.
Originally, bluetooth have its own master branch(feature/btdm_bluedroid), all the bluetooth sub branch will merge to feature/btdm_bluedroid firstly. If feature/btdm_bluedroid is ready, it will request merge to master. But as Ivan/JG/Jack's requires, all the bluetooth bugfix or feature will request merge to master ASAP.
This MR contains "cleanup warning " and "some bug fix", after, every merge request only contain one thing.
See merge request !286
