This commit fixes gpio_hold_en(pin) function for ESP32, where after wakeup from deep sleep, the pin gets reset to default state and stop holding the pin level.
When working in continuous mode, hardware will continuously trigger
ADC to do conversions. On esp32s2, 2 bytes will be generated per
conversion. Prior to this commit, driver assumes 4 bytes per conversion
(on s2). This commit fixed this issue.
Prior to this change, esp32s3 ADC continuous mode output resolution is 13 bits.
This commit correct the `adc_digi_output_data_t` on esp32s3. Correct
output bits should be 12 bits. Corresponding definition in `soc_caps.h`
is also updated.
1. Rename MACROs SYSTEM_WIFI_RST_EN register bit fields to be more recognizable
2. reset Bluetooth baseband and MAC bits to fix the issue of task watchdog triggered during controller initialization due to invalid hardware state
This commit fixes the systimer_counter_value_t by adding a resreved field so that the
type fills 64-bits.
Without the reserved field, when compiling with -O0 optimization, the unoccupied high
bits would not be initalized by the compiler, leading to systimer_hal_get_counter_value()
returning a garbage value.
Since ulp wakeup signal are connected to ulp int raw(except esp32), we
need to clear ulp int raw before sleep when ulp wakeup enabled. Otherwise,
if the ulp int raw is already set, chip will not sleep properly.
Closes https://github.com/espressif/esp-idf/issues/6229
mask_get_id and gpio_hal_iomux_func_sel were called while cache
is disabled, but were not inlined as expected at -0O.
Force these functions to always be inlined.
Hub Driver is refactored as follows:
This commit update and refactors the Hub Driver as follows:
- Refactored enumeration state machine and stage functions
- Enumeration stage is now incremented
- Combined transfer stages of enumeration into common functions
- Comments updated
- Fixed usbh_hal_disable_debounce_lock() that would cause root_port_handle_events()
to fail the HCD_PORT_CMD_RESET call because the previous port connection interrupt
was not cleared.
The following features were added to the Hub Driver
- Enumeration config descriptor is now fetched in two separate stages
- Header is fetched first to determine the wTotalLength of the descriptor
- Fetching the full descriptor will request exactly wTotalLength bytes
- This works around some non-compliant devices that will babble/return zero
when requesting a length > wTotalLength
- Closes https://github.com/espressif/esp-idf/issues/7799
- Enumeration now stores string descriptors
- The Manufacturer, Product, and Serial Number string descriptors are
now read and stored during enumeration
- String descriptors are now part of usb_device_info_t
- Added unit test to test enumeration
This commit updates the USB Host stack to use the USB PHY driver. The
USB PHY and the OTG Controller should now both be setup/deleted using
usb_new_phy() and usb_del_phy() respectively.
- The hcd_install() now expects the USB PHY and OTG Contorller to be
already setup before it is called
- usb_host_install() now has an option to skip calling usb_del_phy() if
the user wants to setup their own USB PHY (e.g., in the case of using
and external PHY).
- CDC-ACM and MSC examples/test updated to use internal PHY
Closes https://github.com/espressif/esp-idf/issues/8061
