Rewrite ble dynamic prio to fix ble disconn in conn_param_update/channel_map_update
Rewrite ble dynamic prio in connection establishment
Fix ble dynamic prio with latency
Fix status bit set error when conn fail
Remove description of unusable API esp_wifi_restart()
Update esp_now_fetch_peer discription
Update table format prblm for esp_wifi_set_max_tx_power()
Update description for ssid and password
1. Fix FIX-ROOT does not reconnect to router when disconnect reason is too many
2. Add API esp_mesh_print_scan_result
3. Modify not to reset mesh_xonseq of self and children when flush_upstream_packets
4. Fix not switch to a parent candidate which has the same layer and assoc as current parent
5. Fix not arm parent monitor when a parent candidate is cleared without sending an event to mesh layer
6. Fix the new voted root does not reconnect to router if rssi is weak
1. add sta connect again ap sent disconnect event
2. add set/get inactive time api
3. fix connect hidden AP doesn't update information
4. add rf test long short support
1. Fix TX DMA buffer issue
2. API esp_wifi_get_config add acquisition sta.listen_interval
3. Configure bandwidth and phy mode to store NVS
4. If AP's tsf has been restarted, STA will disconnect from AP.
5. Do not reset softAP's tsf except it restart
6. Fix the wifi regdomain update bug
7. Fix the bug for airkiss find hidden AP fail
8. Fix addba and first ampdu send bar
9. Fix WiFi fragment issue
10. Fix WiFi fragment issue
1. If the root is specified (FIXED-ROOT) by set type or set parent, change ie.mesh_type to MESH_ROOT before connect to router.
2. Release esp_mesh_recv_toDS when the root becomes non-root.
3. esp_mesh_set_type now supports MESH_IDLE and MESH_STA.
4. Fix ie.rc_rssi is not updated during scan and vote.
5. Fix ie.mesh_type do not match ie.layer caused by parent switch.
6. Fix during root switch, the original root doesn't disconnect from the router after it receives the switch request from the new voted root. (root switch happens by invoking esp_mesh_waive_root).
7. Fix the routing announce timer is not stopped immediately in a new root if the new root is transformed from non-root.
8. Choose the candidate with less ie.assoc when doing parent switch.
1. fix the bug for softAP update second channel wrong
2. change wifi_scan_time_t from union to struct
3. query country code wrong when policy change from manual to auto
4. fix the crash issue when fetch peer after delete the cur_peer
5. fix the timeout issue of EAPOL four-way handshake
1. Add wifi stop check at wifi deinit entry.
2. Add TX packets size check.
3. Reduce wifi bin size.
4. Fix the bug for setting channel when wifi in NULL mode.
5. Place the Vendor Specific element at the end according to the protocol.
6. Coex adjust scheme when bt is in connnected status.
components/esp_wifi: improve coexistence performance according to specific WiFi/BT/BLE scienario (Backport v3.3)
See merge request espressif/esp-idf!7410
1. Improve WiFi throughput in some Classic BT scienarios(idle, inquire scan,
connected, sniff, a2dp pause, etc).
2. Support WiFi + Classic BT + BLE mesh coexistence scienario.
3. Improve WiFi scan and connect succeed ratio in coexistence scienario.
4. Do not support to choose software coexistence preference anymore for it is
determined according to coexistence scienario automatically.
components/lwip: increase TCP send buffer and receive window limitation when TCP window scale is enabled
components/ble_mesh: Fix some bugs about ble mesh
1. fix send acl pkt after ble have sent terminate ind modify min adv interval to 10ms.
1. Fix WiFi scan leads to poor performance of Bluetooth.
2. Improve WiFi connect success ratio when coexist with Bluetooth.
3. Check if WiFi is still connected when CSA or beacon timeout happen.
4. add coex pre init
1. Fix high beacon and broadcast packets loss ratio of WiFi to make
MDNS test pass.
2. Improve stability of WiFi performance with a little
sacrifice of throughput.
3. Improve BLE advertising and connection performance with dynamic
priority. It sacrifices a little WiFi throughput, but achieves balance
between WiFi and Bluetooth.
4. fix bug bb reset lock flag to avoid bb reset lock unhandle
5. fix bug wifi reset mac cause task watch dog timeout
6. fix bug wifi reset mac position
Fix following WiFi bugs:
1. Fix the bug that wpa2 enterprise sta can connect open AP
2. Fix TKIP/CCMP PN replay attack detection bug
3. Increase buffer number type from uint8_t to uint16_t to support more than 255 buffers
4. Avoid recalculating PMK if esp_wifi_set_config() is not called
5. Fix the bug that scan done leads to crash because of uint8 overflow
6. Fix 5.5M signal test bug
We fixed some flash bugs in bootloader, but for the users used the old
vrsion bootloader, they can not fix these bugs via OTA, the solution is
add these updates in app startup.
These updates include:
1. SPI flash gpio matrix and drive strength configuration
2. SPI flash clock configuration
3. SPI flash read dummy configuration
4. SPI flash cs timing configuration
5. Update flash id of g_rom_flashchip
1. resend eb which are pending in g_ic.tx_buf due to channel switch.
2. add lock for mgmg/xon/bcast to protect send from user flush.
3. softap: add check if secondary offset is correct when start softap.
4. softap: in inactive timer handler, add check if child bss is removed to avoid removing it again.
5. disable A-MPDU for non-root.
6. fix reusing a freed eb.
7. fix when node becomes root, it does not record assoc value to nvs.
8. discard unnecessary forwarded group packets.
9. fix toDS state is not updated in time.
10. fix s_sta_cnx_times is not cleared when deinit causes root sends ADD annoucement.
11. root: increase beacon timeout time from 6 seconds to 15 seconds to delay initiation of reconnection.
12. add esp_mesh_get_tsf_time to return TSF time.
13. send the whole routing table multi-times.
14. clear candidate settings if not receive candidate beacon within 8 seconds.
When flash work in DIO Mode, in order to ensure the fast read mode of flash
is a fixed value, we merged the mode bits into address part, and the fast
read mode value is 0 (the default value).
