1. Add support for SAE-PK and WPA3-Enterprise transition disable
2. Add support to handle OWE transition disable indication from AP
3. refactor: Backport common changes in scan/connect path from 90cc6158
- 90cc6158 adds support for Network Introduction Protocol in DPP
4. Fix issue of supplicant using wrong parameters to configure bss
- Ensure that wpa_supplicant's state machine registers the requirement for rsnxe
before deciding to add rsnxe to a assoc request.
Co-authored-by: jgujarathi <jash.gujarathi@espressif.com>
1. Fix issues related to mgmt packets encryption in GCMP
2. Fix issue of wrong decryption of mgmt packets when PMF is enabled
3. Fix frame subtype in send_mgmt_frame
4. Fix issue of wrong Rx control information of espnow packets for esp32 and esp32s2
5. Fix send mgmt err when eapol process
1. Free temporary data used by SAE before memsetting the same
2. Drop any received auth response that uses a different algorithm than the one currently in use
* Improvements in scan and connect path as per specifications along with
minor bugfixes
* When AP advertises all PSK modes (WPA, WPA2 and WPA3), make sure that
station treats it as WPA2_WPA3_PSK mixed mode.
1. fix esp_wifi_set_mode() return error issue
2. fix qos encapsulated eapol issue
3. eapol arp and dhcp add flag PP_F_PER_PKT_RATE
4. fix lmac_stop_hw_txq issue
5. fix typo
6. limite number of amsdu block in eb
7. fix recycle cache sub amsdu eb issue
8. update ba session store and restore rx ba num
9. fix multicast address qos frame by reset rx ba
10. fix lmacStopTransmit issue
11. sync multi antenna gpio register from IDF
12. clear eb to fix tx single AMPDU to some AP not reply BA when ampdu_entry single bit was set
13. fix internal set log level check fail issue
14. update esp_wifi_connect doc
15. update api esp_wifi_sta_get_rssi docs
16. add interupt lock during hardware reload of Rx link
Update wifi libs with below -
1. Break FTM State Machine code into separate functions
2. Use dynamic allocation for FTM session to save memory
3. Add API to get FTM report instead of event based mechanism
4. Add FTM Request retry and comeback support
Removed rogue semicolon from SMARTCONFIG_START_CONFIG_DEFAULT() macro. This
fixes build issues when this macro is used via C++ brace initialization.
Closes https://github.com/espressif/esp-idf/pull/12867
[Darian Leung: Updated commit message]
Signed-off-by: Darian Leung <darian@espressif.com>
1. fix(wifi): fix the crash issue when clear scan ap list
2. fix the bug that station can't found AP when the authmode is WPA
2. fix wifi mode error when mesh start after station has connected to router
