docs: Update zh_CN translation for MR32736

docs/en/api-reference/network/esp_eth.rst

@@ -138,7 +138,7 @@ The Ethernet driver is composed of two parts: MAC and PHY.
         * Force the PHY device to reset status (as the case *a* in the picture). **This could fail for some PHY device** (i.e. it still outputs signals to GPIO0 even in reset state).
 
     .. warning::
-        If you want the **Ethernet to work with WiFi**, don’t select ESP32 as source of ``REF_CLK`` as it would result in ``REF_CLK`` instability. Either disable WiFi or use a PHY or an external oscillator as the ``REF_CLK`` source.
+        If you want the **Ethernet to work with Wi-Fi**, don’t select ESP32 as source of ``REF_CLK`` as it would result in ``REF_CLK`` instability. Either disable Wi-Fi or use a PHY or an external oscillator as the ``REF_CLK`` source.
 
     **No matter which RMII clock mode you select, you really need to take care of the signal integrity of REF_CLK in your hardware design!** Keep the trace as short as possible. Keep it away from RF devices and inductor elements.
 

docs/zh_CN/api-reference/network/esp_eth.rst

@@ -142,6 +142,10 @@ ESP-IDF 提供一系列功能强大且兼具一致性的 API，为内部以太
     .. note::
         ESP-IDF 只支持 RMII 接口（即在 Kconfig 选项 :ref:`CONFIG_ETH_PHY_INTERFACE` 中始终选择 ``CONFIG_ETH_PHY_INTERFACE_RMII``）。
 
+    .. warning::
+            如希望 **以太网与 Wi-Fi 一起工作**，不要选择 ESP32 作为 ``REF_CLK`` 的源，因为这会导致 ``REF_CLK`` 不稳定。可以选择禁用 Wi-Fi，或使用 PHY 或外部振荡器作为 ``REF_CLK`` 的源。
+
+
         在数据平面使用的信号通过 MUX 连接至特定的 GPIO，这些信号无法配置至其他 GPIO。在控制平面使用的信号则可以通过 Matrix 矩阵路由到任何空闲 GPIO。相关的硬件设计示例，请参考 `ESP32-Ethernet-Kit <https://docs.espressif.com/projects/esp-dev-kits/zh_CN/latest/esp32/esp32-ethernet-kit/index.html>`_。
 
 根据您的以太网板设计，需要分别为 MAC 和 PHY 配置必要的参数，通过两者完成驱动程序的安装。