esp-idf/components/openthread/Kconfig

menu "OpenThread"

    config OPENTHREAD_ENABLED
        bool "OpenThread"
        default n
        help
            Select this option to enable OpenThread and show the submenu with OpenThread configuration choices.

    choice OPENTHREAD_RADIO_TYPE
        prompt "Config the Thread radio type"
        depends on OPENTHREAD_ENABLED
        default OPENTHREAD_RADIO_NATIVE if IDF_TARGET_ESP32H2
        default OPENTHREAD_RADIO_SPINEL_UART
        help
            Configure how OpenThread connects to the 15.4 radio

        config OPENTHREAD_RADIO_NATIVE
            bool "Native 15.4 radio"
            help
                Select this to use the native 15.4 radio.

        config OPENTHREAD_RADIO_SPINEL_UART
            bool "Connect via UART"
            help
                Select this to connect to a Radio Co-Processor via UART.
    endchoice

    choice OPENTHREAD_DEVICE_TYPE
        prompt "Config the Thread device type"
        depends on OPENTHREAD_ENABLED
        default OPENTHREAD_FTD
        help
            OpenThread can be configured to different device types (FTD, MTD, Radio)

        config OPENTHREAD_FTD
            bool "Full Thread Device"
            help
                Select this to enable Full Thread Device which can act as router and leader in a Thread network.

        config OPENTHREAD_MTD
            bool "Minimal Thread Device"
            help
                Select this to enable Minimal Thread Device which can only act as end device in a Thread network.
                This will reduce the code size of the OpenThread stack.

        config OPENTHREAD_RADIO
            bool "Radio Only Device"
            help
                Select this to enable Radio Only Device which cannot can only forward 15.4 packets to the host.
                The OpenThread stack will be run on the host and OpenThread will have minimal footprint on the
                radio only device.
    endchoice

    config OPENTHREAD_DIAG
        bool "Enable diag"
        depends on OPENTHREAD_ENABLED
        default y
        help
            Select this option to enable Diag in OpenThread. This will enable diag mode and a series of diag commands
            in the OpenThread command line. These commands allow users to manipulate low-level features of the storage
            and 15.4 radio.

    config OPENTHREAD_COMMISSIONER
        bool "Enable Commissioner"
        depends on OPENTHREAD_ENABLED
        default n
        help
            Select this option to enable commissioner in OpenThread. This will enable the device to act as a
            commissioner in the Thread network. A commissioner checks the pre-shared key from a joining device with
            the Thread commissioning protocol and shares the network parameter with the joining device upon success.

    config OPENTHREAD_JOINER
        bool "Enable Joiner"
        depends on OPENTHREAD_ENABLED
        default n
        help
            Select this option to enable Joiner in OpenThread. This allows a device to join the Thread network with a
            pre-shared key using the Thread commissioning protocol.

    config OPENTHREAD_BORDER_ROUTER
        bool "Enable Border Router"
        depends on OPENTHREAD_ENABLED
        default n
        help
            Select this option to enable border router features in OpenThread.

    config OPENTHREAD_ESP_LIB_FROM_INTERNAL_SRC
        bool "Build esp_openthread libraries from source"
        depends on OPENTHREAD_ENABLED
        default n
        help
            Override the shipped libopenthread_br.a and libopenthread_port.a, for internal builds.

    config OPENTHREAD_NUM_MESSAGE_BUFFERS
        int "The number of openthread message buffers"
        depends on OPENTHREAD_ENABLED
        default 65
        range 50 100

endmenu