You can skip the introduction sections and go directly to Section `Start Application Development`_.
.._DevKitC-Overview:
Overview
--------
ESP32-DevKitC V4 is a small-sized ESP32-based development board produced by `Espressif <https://espressif.com>`_. Most of the I/O pins are broken out to the pin headers on both sides for easy interfacing. Developers can either connect peripherals with jumper wires or mount ESP32-DevKitC V4 on a breadboard.
To cover a wide range of user requirements, the following versions of ESP32-DevKitC V4 are available:
- A module with ESP32 at its core. For more information, see `ESP32-WROOM-32 Datasheet`_.
* - EN
- Reset button.
* - Boot
- Download button. Holding down **Boot** and then pressing **EN** initiates Firmware Download mode for downloading firmware through the serial port.
* - USB-to-UART Bridge
- Single USB-UART bridge chip provides transfer rates of up to 3 Mbps.
* - Micro USB Port
- USB interface. Power supply for the board as well as the communication interface between a computer and the ESP32-WROOM-32 module.
* - 5V Power On LED
- Turns on when the USB or an external 5V power supply is connected to the board. For details see the schematics in `Related Documents`_.
* - I/O
- Most of the pins on the ESP module are broken out to the pin headers on the board. You can program ESP32 to enable multiple functions such as PWM, ADC, DAC, I2C, I2S, SPI, etc.
The pins D0, D1, D2, D3, CMD and CLK are used internally for communication between ESP32 and SPI flash memory. They are grouped on both sides near the USB connector. Avoid using these pins, as it may disrupt access to the SPI flash memory / SPI RAM.
The pins GPIO16 and GPIO17 are available for use only on the boards with the modules ESP32-WROOM and ESP32-SOLO-1. The boards with ESP32-WROVER modules have the pins reserved for internal use.
The two tables below provide the **Name** and **Function** of I/O header pins on both sides of the board, as shown in :ref:`get-started-esp32-devkitc-board-front`. The numbering and names are the same as in the `ESP32-DevKitC V4 schematics`_ (PDF).
:alt:Location of C15 (colored yellow) on ESP32-DevKitC V4 board
:figclass:align-center
:width:30%
Location of C15 (yellow) on ESP32-DevKitC V4 board
Start Application Development
------------------------------
Before powering up your ESP32-DevKitC V4, please make sure that the board is in good condition with no obvious signs of damage.
After that, proceed to :doc:`../../get-started/index`, where Section :ref:`get-started-step-by-step` will quickly help you set up the development environment and then flash an example project onto your board.
