esp-idf/examples/zigbee/light_sample/HA_on_off_light/README.md

51 lines
2.0 KiB
Markdown
Raw Normal View History

| Supported Targets | ESP32-H2 |
| ----------------- | -------- |
# Light Bulb Example
This test code shows how to configure Zigbee end device and use it as HA on/off light bulb
## Hardware Required
* One development board with ESP32-H2 SoC acting as Zigbee end device (loaded with HA_on_off_light example)
* A USB cable for power supply and programming
* Choose another ESP32-H2 as Zigbee coordinator (see [HA_on_off_switch example](../HA_on_off_switch))
## Configure the project
Before project configuration and build, make sure to set the correct chip target using `idf.py set-target esp32h2`.
## Erase the NVRAM
Before flash it to the board, it is recommended to erase NVRAM if user doesn't want to keep the previous examples or other projects stored info using `idf.py -p PORT erase-flash`
## Build and Flash
Build the project, flash it to the board, and start the monitor tool to view the serial output by running `idf.py -p PORT flash monitor`.
(To exit the serial monitor, type ``Ctrl-]``.)
## Example Output
As you run the example, you will see the following log:
light bulb:
I (918) ESP_ZB_LIGHT: status: 255
I (901) ESP_ZB_LIGHT: Zigbee stack initialized
I (901) ESP_ZB_LIGHT: Start network steering
I (2611) ESP_ZB_LIGHT: Joined network successfully (Extended PAN ID: aa:98:48:01:a0:03:f7:84, PAN ID: 0x0e8b)
I (5651) ESP_ZB_LIGHT: on/off light set to 1
I (6631) ESP_ZB_LIGHT: on/off light set to 0
I (7331) ESP_ZB_LIGHT: on/off light set to 1
I (8251) ESP_ZB_LIGHT: on/off light set to 0
I (9111) ESP_ZB_LIGHT: on/off light set to 1
I (9671) ESP_ZB_LIGHT: on/off light set to 0
## Light Control Functions
* By toggling the switch button (BOOT) on the ESP32-H2 board loaded with the `HA_on_off_switch` example, the LED on this board loaded with `HA_on_off_light` example will be on and off.
## Troubleshooting
For any technical queries, please open an [issue](https://github.com/espressif/esp-idf/issues) on GitHub. We will get back to you soon.