esp-idf/examples/system/deep_sleep/main/Kconfig.projbuild

71 lines
3.0 KiB
Plaintext
Raw Normal View History

2017-01-27 11:00:31 -05:00
menu "Example Configuration"
2020-04-22 10:46:23 -04:00
config EXAMPLE_TOUCH_WAKEUP
bool "Enable touch wake up"
default y
depends on SOC_PM_SUPPORT_TOUCH_SENSOR_WAKEUP
help
This option enables wake up from deep sleep using touch pads
TOUCH8 and TOUCH9, which correspond to GPIO33 and GPIO32.
2017-01-27 11:00:31 -05:00
config EXAMPLE_EXT0_WAKEUP
bool "Enable wakeup from GPIO (ext0)"
default y
depends on !SOC_GPIO_SUPPORT_DEEPSLEEP_WAKEUP
help
This option enables wake up from deep sleep from GPIO3. They should be connected to LOW to avoid
floating pins. When triggering a wake up, connect one or both of the pins to HIGH. Note that floating
pins may trigger a wake up.
2020-04-22 10:46:23 -04:00
config EXAMPLE_EXT1_WAKEUP
bool "Enable wakeup from GPIO (ext1)"
2020-04-22 10:46:23 -04:00
default y
depends on !SOC_GPIO_SUPPORT_DEEPSLEEP_WAKEUP
2020-04-22 10:46:23 -04:00
help
This option enables wake up from deep sleep from GPIO2 and GPIO4. They should be connected to LOW to avoid
floating pins. When triggering a wake up, connect one or both of the pins to HIGH. Note that floating
pins may trigger a wake up.
config EXAMPLE_EXT1_USE_INTERNAL_PULLUPS
bool "Use internal pull-up/downs for EXT1 wakeup source"
default n
depends on EXAMPLE_EXT1_WAKEUP
help
When using EXT1 wakeup source without external pull-up/downs, you may want to make use of the internal
ones.
However, the RTC IO reside in the RTC Periph power domain. Enable this option to force that power domain
ON during deep sleep. Note that this will increase some power comsumption, so it's still suggested to use
external ones instead.
EXT0 wakeup source resides in the same power domain as RTCIO (RTC Periph), so internal pull-up/downs are
always available. There's no need to explicitly force it on for EXT0.
config EXAMPLE_GPIO_WAKEUP
bool "Enable wakeup from GPIO"
default y
depends on SOC_GPIO_SUPPORT_DEEPSLEEP_WAKEUP
help
This option enables wake up from GPIO. Be aware that if you use low level to trigger wakeup, we strongly
recommand you to connect external pull-up resistance.
menu "GPIO wakeup configuration"
visible if SOC_GPIO_SUPPORT_DEEPSLEEP_WAKEUP
config EXAMPLE_GPIO_WAKEUP_PIN
int "Enable wakeup from GPIO"
default 0 if !IDF_TARGET_ESP32H2_BETA_VERSION_2
default 7 if IDF_TARGET_ESP32H2_BETA_VERSION_2
range 0 5 if !IDF_TARGET_ESP32H2_BETA_VERSION_2
range 7 12 if IDF_TARGET_ESP32H2_BETA_VERSION_2
config EXAMPLE_GPIO_WAKEUP_HIGH_LEVEL
bool "Enable GPIO high-level wakeup"
default y
help
This option set the gpio wake-up trigger signal, In deep sleep, only high or low level wake-up is
supported. If this option is enabled, it is a high level wake up, otherwise it is a low level wake up.
endmenu
2020-04-22 10:46:23 -04:00
endmenu