| AnimationDemo | ||
| components/ssd1306 | ||
| ImageDemo | ||
| MeterDemo | ||
| TextDemo | ||
| WrapAroundDemo | ||
| LICENSE | ||
| README.md | ||
esp-idf-ssd1306
SSD1306/SH1106 driver for esp-idf
I used this repository as a reference.
I used this font file.
Software requirements
esp-idf v4.4 or later.
This is because this version supports ESP32-C3.
Installation for
git clone https://github.com/nopnop2002/esp-idf-ssd1306
cd esp-idf-ssd1306/TextDemo/
idf.py set-target {esp32/esp32s2/esp32s3/esp32c3}
idf.py menuconfig
idf.py flash
Note
For some reason, there are development boards that cannot use GPIO06, GPIO08, GPIO09, GPIO19 for SPI clock pins.
According to the ESP32C3 specifications, these pins can also be used as SPI clocks.
I used a raw ESP-C3-13 to verify that these pins could be used as SPI clocks.
Configuration
You have to set this config value with menuconfig.
- CONFIG_INTERFACE
- CONFIG_PANEL
- CONFIG_OFFSETX
- CONFIG_FLIP
- CONFIG_SDA_GPIO
- CONFIG_SCL_GPIO
- CONFIG_RESET_GPIO
- CONFIG_MOSI_GPIO
- CONFIG_SCLK_GPIO
- CONFIG_CS_GPIO
- CONFIG_DC_GPIO
Generic SSD1306 128x32 i2c
Generic SSD1306 128x64 i2c
Generic SH1106 128x64 i2c
Hardware scroll Not support
Left:1.3 inch SH1106
Right:0.96 inch SSD1306
128x64 TTGO
Unlike other ESP32 development boards, the RTC_CLOCK crystal on this board uses a 26MHz one.
You need to change the RTC CLOCK frequency to 26MHz using menuconfig.
128x64 ESP-WROOM-32
Generic SSD1306 128x32 SPI
Generic SSD1306 128x64 SPI
D0 is SCLK.
D1 is MOSI.
Generic SH1106 128x64 SPI
Hardware scroll Not support
Left:1.3 inch SH1106
Right:0.96 inch SSD1306
Flip upside down
