GY-63_MS5611/libraries/DAC8552

DAC8552

Arduino library for DAC8552 SPI Digital Analog Convertor

Description

The DAC8552 is a SPI based 16 bit DAC with two channels.

Warning This library is not tested extensively

Interface

Core

• DAC8552(uint8_t slaveSelect) Constructor for hardware SPI, since 0.2.0 the slaveSelect pin needs to be defined.
• DAC8552(uint8_t spiData, uint8_t spiClock, uint8_t slaveSelect) Constructor for the software SPI
• void begin() initializes all pins to default state
• void bufferValue(uint8_t channel, uint16_t value)
• void setValue(uint8_t channel, uint16_t value) set the value of the chosen channel to 0 - 65535
• **uint16_t getValue(uint8_t channel)**returns the last value written.

Hardware SPI

To be used only if one needs a specific speed.

• void setSPIspeed(uint32_t speed) set SPI transfer rate.
• uint32_t getSPIspeed() returns SPI transfer rate.
• bool usesHWSPI() returns true if HW SPI is used.

ESP32 specific

• void selectHSPI() in case hardware SPI, the ESP32 has two options HSPI and VSPI.
• void selectVSPI() see above.
• bool usesHSPI() returns true if HSPI is used.
• bool usesVSPI() returns true if VSPI is used.

The selectVSPI() or the selectHSPI() needs to be called BEFORE the begin() function.

experimental

• void setGPIOpins(uint8_t clk, uint8_t miso, uint8_t mosi, uint8_t select) overrule GPIO pins of ESP32 for hardware SPI. needs to be called AFTER the begin() function.

Power down

Check datasheet for details.

• void bufferPowerDown(uint8_t channel, uint8_t powerDownMode) ets power down mode. 0 - 3, but waits until (TODO CHECK DATASHEET)
• void setPowerDown(uint8_t channel, uint8_t powerDownMode) sets power down mode. 0 - 3.
• uint8_t getPowerDownMode(uint8_t channel) returns last written mode.

Power down mode	Value
DAC8552_POWERDOWN_NORMAL	0
DAC8552_POWERDOWN_1K	1
DAC8552_POWERDOWN_100K	2
DAC8552_POWERDOWN_HIGH_IMP	3

Future

• testing

Operation

See examples

demo_hw_spi.ino

• write a sawtooth to channel A followed by a sinus
• uses HW SPI

demo_sw_spi.ino

• write a sawtooth to channel A followed by a sinus
• uses SW SPI

demo_same_time_write.ino

• writes two square waves that trigger at the same time

demo_sequential_write.ino

• writes two square waves sequentially (slight time difference)

demo_powerdown.ino

• idem