GY-63_MS5611/libraries/Stopwatch_RT

Stopwatch_RT

Arduino Library implementing a stopwatch including seconds, milliseconds microseconds

Description

The stopwatch class allows one to create a stopwatch with 4 levels of resolution

• MICROS - microseconds
• MILLIS - milliseconds (default)
• SECONDS - seconds
• MINUTES - minutes (added 0.2.0)

Note that the resolution chosen implies the finest granularity of units measured. E.g. if chosen minutes then one cannot measure half (30 sec) or other part of a minute.

The resolution is typically set in the constructor, however since 0.2.0 one can call setResolution() to change the 'tick unit' of the clock runtime. This way one can reuse the stopwatch object without creating a new one and thereby save some memory.

Warning: Changing the resolution will reset the stopwatch as start time and stop time will become meaningless. The stopwatch will reset even when the resolution is the current resolution.

This library is based upon millis() and micros() and therefore has the same restrictions and limitations as these functions with respect to overflow and precision. This means minutes and seconds will overflow also after about 49 days.

Interface

Core

• StopWatch(resolution = MILLIS) constructor, with default resolution.
• void start() start counting
• void stop() stop counting
• uint32_t elapsed() returns the time in chosen units since last start()
• void reset() resets the counting to 0.

The use of value() is depreciated, use elapsed() instead.

Status

• bool isRunning() returns true if clock is counting.
• enum state() returns RESET, RUNNING or STOPPED.
• void setResolution(resolution) - changes the resolution of the stopwatch and resets it. Even when called with the current resolution a reset will take place.
• enum resolution() returns MICROS, MILLIS, SECONDS or MINUTES

Printable

As the stopwatch implements the printable interface from 0.3.1 one can call

Serial.println(stopwatch);

To get output like "115 ms" or "159753 us" including the units.

Calibration

If processors internal clock are not accurately enough, one can adjust two constants in the StopWatch.h file. Use ar own risk..

• STOPWATCH_SECONDS_DIVIDER
• STOPWATCH_MINUTES_DIVIDER

Future

• with rising of faster processors in Arduino eco system, NANOS might added. Be aware that these short timeframes are better measured e.g. by a hardware timer.
• create getters and setters for the calibration constants so they can changed under program control.

Operation

See examples