GY-63_MS5611/libraries/GY521/examples/test1/test1.ino

//
//    FILE: test1.ino
//  AUTHOR: Rob Tillaart
// VERSION: 0.1.0
// PURPOSE: minimal demo
//    DATE: 2020-07-01

#include "GY521.h"

GY521 sensor(0x69);

uint32_t counter = 0;

void setup()
{
  Serial.begin(115200);
  Serial.println(__FILE__);

  Wire.begin();

  delay(100);
  while (sensor.wakeup() == false)
  {
    Serial.print(millis());
    Serial.println("\tCould not connect to GY521");
    delay(1000);
  }
  sensor.setAccelSensitivity(0);  // 2g
  sensor.setGyroSensitivity(0);   // 250 degrees/s

  sensor.setThrottle();
  Serial.println("start...");
  
  // set callibration values from calibration sketch.
  sensor.axe = 0;
  sensor.aye = 0;
  sensor.aze = 0;
  sensor.gxe = 0;
  sensor.gye = 0;
  sensor.gze = 0;
}

void loop()
{
  sensor.read();
  int ax = sensor.getAccelX();
  int ay = sensor.getAccelY();
  int az = sensor.getAccelZ();
  int gx = sensor.getGyroX();
  int gy = sensor.getGyroY();
  int gz = sensor.getGyroZ();
  int t = sensor.getTemperature();

  if (counter % 10 == 0)
  {
    Serial.println("\n\tACCELEROMETER\t\tGYROSCOPE\t\tTEMPERATURE");
    Serial.println("\tax\tay\taz\tgx\tgy\tgz\tT");
  }

  Serial.print(counter);
  Serial.print('\t');
  Serial.print(ax);
  Serial.print('\t');
  Serial.print(ay);
  Serial.print('\t');
  Serial.print(az);
  Serial.print('\t');
  Serial.print(gx);
  Serial.print('\t');
  Serial.print(gy);
  Serial.print('\t');
  Serial.print(gz);
  Serial.print('\t');
  Serial.print(t);
  Serial.println();

  counter++;
  delay(1000);
}

// -- END OF FILE --